[Healeys] BN2 Trans Dowel Bolts

[Michael Salter]

Perry I  would think that the bigger problem would be the gear alignment.
If the forward end on the input shaft were to be displaced the input gear
would engage with the laygear at an angle. .. not good.

M

On Sat., Mar. 27, 2021, 6:26 p.m. Perry Small via Healeys, <
healeys at autox.team.net> wrote:

>
>
>
> More useless information. Using a regular 3/8 UNF bolt with a long enough
> shank could potentially allow the bell housing to hang 0.001 inch low on
> the engine back plate.
> The play in a new input shaft bearing will allow the tip of shaft (where
> it enters the bushing in the crank) to move, much more than 0.001. So is
> alignment really an issue with tolerances this small?
> P
>
> Sent from my iPhone_______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/healeys
> http://autox.team.net/archive
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/michaelsalter@gmail.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20210327/28afcdba/attachment.htm>