[Healeys] pilot bush quest

[Bob Spidell]

I don't have a first motion/input shaft to look at, but I don't recall a 
flange or step that would prevent the shaft from going fully into the 
flywheel (something in the pilot bush hole could, though). However, I'd 
want to know why the bush won't go in fully; is it the wrong part, or is 
there crud in the hole, or ...


On 8/20/2021 5:52 PM, Tom Felts via Healeys wrote:
>
> it sits 1/16 of an inch from the rear ridge.
>
>
> ----- Original Message -----
> From: Tom Felts <tomfelts at windstream.net>
> To: healeys <healeys at autox.team.net>
> Sent: Fri, 20 Aug 2021 20:49:09 -0400 (EDT)
> Subject: pilot bush quest
>
> try as I may I cannot get the pilot bush to seat flush in the motion 
> shaft opening.  if I do not get it flush against the ridge in the 
> opening will this prevent the shaft from going in deep enough to allow 
> the tranny to mate flush to the engine-----?
>
> Thanks
> Tom
>
>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20210820/80a1480b/attachment.htm>