<html>
<head>
<meta http-equiv="Content-Type" content="text/html; charset=UTF-8">
</head>
<body>
I don't have a first motion/input shaft to look at, but I don't
recall a flange or step that would prevent the shaft from going
fully into the flywheel (something in the pilot bush hole could,
though). However, I'd want to know why the bush won't go in fully;
is it the wrong part, or is there crud in the hole, or ...<br>
<br>
<br>
<div class="moz-cite-prefix">On 8/20/2021 5:52 PM, Tom Felts via
Healeys wrote:<br>
</div>
<blockquote type="cite"
cite="mid:1855857848.205868715.1629507125632.JavaMail.zimbra@windstream.net">
<meta http-equiv="content-type" content="text/html; charset=UTF-8">
<style>body {height: 100%; color:#000000; font-size:12pt; font-family:arial, helvetica, sans-serif;}</style>
<div><br>
</div>
<div>it sits 1/16 of an inch from the rear ridge.</div>
<div><br data-mce-bogus="1">
</div>
<div><br data-mce-bogus="1">
</div>
<div>----- Original Message -----<br>
From: Tom Felts <a class="moz-txt-link-rfc2396E" href="mailto:tomfelts@windstream.net"><tomfelts@windstream.net></a><br>
To: healeys <a class="moz-txt-link-rfc2396E" href="mailto:healeys@autox.team.net"><healeys@autox.team.net></a><br>
Sent: Fri, 20 Aug 2021 20:49:09 -0400 (EDT)<br>
Subject: pilot bush quest<br>
</div>
<div><br>
</div>
<style>body {height: 100%; color:#000000; font-size:12pt; font-family:arial, helvetica, sans-serif;}</style>
<div>try as I may I cannot get the pilot bush to seat flush in the
motion shaft opening. if I do not get it flush against the
ridge in the opening will this prevent the shaft from going in
deep enough to allow the tranny to mate flush to the
engine-----? </div>
<div><br>
</div>
<div>Thanks</div>
<div>Tom</div>
<div><br>
</div>
<br>
</blockquote>
<br>
</body>
</html>