[Healeys] BN2 ft. shroud questions

[sentenac.rw at gmail.com]

Sorry, I misread the question and answered something you didn't ask
about: the shroud to front frame.  Gotta slow down my reading.
 -Roland

On Sat, 12 Sep 2020 07:04:40 -0700, you wrote:

>Four screws per bracket. No pop rivets there
>-Roland
>
>On Sat, Sep 12, 2020, 6:51 AM S and T Miller via Healeys <
>healeys at autox.team.net> wrote:
>
>> The ft. shroud attaches to the front fenders via a flat bracket that is
>> slightly adjustable by two bolts/nuts and attached to the top of the
>> fender.  The fender bolt goes through the bracket, the shroud, and into the
>> fender/ clip.  I have always thought the shroud was attached to that flat
>> bracket by a pop rivet, but when looking at another shroud I see a machine
>> screw/ nut where the nut is on the inside toward the engine compartment
>> (appears original).  Was it originally attached with a machine screw/ nut?
>>
>> I have found several missing holes on my front shroud (BN2). Examples: No
>> holes for bonnet rubber pads. No drain holes (2) at the front of the bonnet
>> opening drain channel.  No holes for the above question.  I'm kinda
>> thinking maybe it was a replacement shroud early on?  Anyone run into this?
>>
>> Thanks all.  Shawn
>>
>> The Millers
>>
>> "Always drive them, but remember each drive in an antique car is a test
>> drive."
>> _______________________________________________
>> Support Team.Net http://www.team.net/donate.html
>> Suggested annual donation  $12.75
>>
>> Archive: http://www.team.net/pipermail/healeys
>> http://autox.team.net/archive
>>
>> Healeys at autox.team.net
>> http://autox.team.net/mailman/listinfo/healeys
>>
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/healeys/sentenac.rw@gmail.com
>>
>>

-- 
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus