[Healeys] BN2 ft. shroud questions
Perry
healeyguy at aol.com
Sat Sep 12 11:04:57 MDT 2020
Shawn
Regarding new or replacement shrouds, my only experience is with a partial shroud many decades ago. As I recall there where no drilled or punched holes in it.
Perry
Sent from Mail for Windows 10
From: S and T Miller via Healeys
Sent: Saturday, September 12, 2020 9:51 AM
To: healeys at autox.team.net
Subject: [Healeys] BN2 ft. shroud questions
The ft. shroud attaches to the front fenders via a flat bracket that is slightly adjustable by two bolts/nuts and attached to the top of the fender. The fender bolt goes through the bracket, the shroud, and into the fender/ clip. I have always thought the shroud was attached to that flat bracket by a pop rivet, but when looking at another shroud I see a machine screw/ nut where the nut is on the inside toward the engine compartment (appears original). Was it originally attached with a machine screw/ nut?
I have found several missing holes on my front shroud (BN2). Examples: No holes for bonnet rubber pads. No drain holes (2) at the front of the bonnet opening drain channel. No holes for the above question. I'm kinda thinking maybe it was a replacement shroud early on? Anyone run into this?
Thanks all. Shawn
The Millers
"Always drive them, but remember each drive in an antique car is a test drive."
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20200912/a5170bd4/attachment.htm>
More information about the Healeys
mailing list