[Healeys] BN2 ft. shroud questions

[Roland Wilhelmy]

Four screws per bracket. No pop rivets there
-Roland

On Sat, Sep 12, 2020, 6:51 AM S and T Miller via Healeys <
healeys at autox.team.net> wrote:

> The ft. shroud attaches to the front fenders via a flat bracket that is
> slightly adjustable by two bolts/nuts and attached to the top of the
> fender.  The fender bolt goes through the bracket, the shroud, and into the
> fender/ clip.  I have always thought the shroud was attached to that flat
> bracket by a pop rivet, but when looking at another shroud I see a machine
> screw/ nut where the nut is on the inside toward the engine compartment
> (appears original).  Was it originally attached with a machine screw/ nut?
>
> I have found several missing holes on my front shroud (BN2). Examples: No
> holes for bonnet rubber pads. No drain holes (2) at the front of the bonnet
> opening drain channel.  No holes for the above question.  I'm kinda
> thinking maybe it was a replacement shroud early on?  Anyone run into this?
>
> Thanks all.  Shawn
>
> The Millers
>
> "Always drive them, but remember each drive in an antique car is a test
> drive."
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/healeys
> http://autox.team.net/archive
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/sentenac.rw@gmail.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20200912/b95b7bdf/attachment.htm>