[Healeys] Clutch slave cylinder

[WILLIAM B LAWRENCE]

3/8” UNF is the thread size. 9/16” is the wrench size.
________________________________
From: Healeys <healeys-bounces at autox.team.net> on behalf of Mark Donaldson <ardmorebusiness at xtra.co.nz>
Sent: Friday, February 7, 2020 1:47:52 AM
To: simon.lachlan at alexarevel.plus.com <simon.lachlan at alexarevel.plus.com>; 'Healeys' <healeys at autox.team.net>
Subject: Re: [Healeys] Clutch slave cylinder


9/16 inch AF or UNF



Mark



Ardmore

NZ



From: simon.lachlan at alexarevel.plus.com <simon.lachlan at alexarevel.plus.com>
Sent: Friday, 7 February 2020 7:17 a.m.
To: 'Healeys' <healeys at autox.team.net>
Subject: [Healeys] Clutch slave cylinder



I am installing a remote clutch bleeder of the type that’s been discussed on this list from time to time. (Comes up from underneath with a bracket that goes under one of the gearbox bolts).

So, I thought I’d replace the clutch pipe and rebuild the slave cylinder at the same time. (Wise?) precautions….certainly, these things are at least 25 years old.

The bleed nipple was solid to the cylinder body as was the pipe and neither would twitch until I had the assembly in a big vice.

The interior of the cylinder was filled with some dried out but slightly greasy flakey nastiness. God knows what.

I need to undo the so-called “nut for hose”, item 18 in the attached. Does anyone know it’s size?

Thanks,

Simon
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20200207/a4a1a830/attachment.htm>