[Healeys] Carb removal

[warthodson at aol.com]

Beautiful wrench remodeling job!Gary Hodson

-----Original Message-----
From: Brian Drab via Healeys <healeys at autox.team.net>
To: Leonard Berkowitz <DrBerkowitz at hotmail.com>; healeys at autox.team.net <healeys at autox.team.net>
Sent: Tue, Dec 1, 2020 2:07 pm
Subject: Re: [Healeys] Carb removal

#yiv5028915257 #yiv5028915257 -- _filtered {} _filtered {}#yiv5028915257 #yiv5028915257 p.yiv5028915257MsoNormal, #yiv5028915257 li.yiv5028915257MsoNormal, #yiv5028915257 div.yiv5028915257MsoNormal {margin:0cm;font-size:11.0pt;font-family:sans-serif;}#yiv5028915257 span.yiv5028915257EmailStyle19 {font-family:sans-serif;color:windowtext;}#yiv5028915257 .yiv5028915257MsoChpDefault {font-size:10.0pt;} _filtered {}#yiv5028915257 div.yiv5028915257WordSection1 {}#yiv5028915257 I too had the problem of removing my carbs, but on a BJ8 - which because of the carb size I think was probably harder. I had to actually modify a perfectly good wrench to get the bottom inside nuts loosened.   A lot of heat and experimenting before I got it right and even then it only gave me enough purchase to probably get 1/16 of a turn of the nut! But loosening the nuts paled in comparison to getting those same nuts back on. Getting each nut actually located on the stud probably took one hour each and it involved using grease on my finger tip to hold the nut in place and try to turn it that first segment of a turn to get it started. Probably one of the worst jobs I have encountered in my years of working on cars. Brian Drab AHOABC    From: Leonard Berkowitz <DrBerkowitz at hotmail.com>
Sent: November 30, 2020 1:40 PM
To: healeys at autox.team.net
Subject: [Healeys] Carb removal    It has been thirty years since the last time I needed to do anything major on my BJ7 so my memory is not quite clear.  Can I remove the rear carb independently from the front carb? I have already designed a tool to access the lower hold down bolts.  If I remember correctly, I may have rebuilt and installed the carburetors when I rebuilt the engine, so access was not much of a problem.    
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20201201/60018947/attachment.htm>