[Healeys] Clutch and brake pedal issue
Tom Felts
Tomfelts at windstream.net
Thu Feb 21 05:50:31 MST 2019
yes---thank you.tom
----- Original Message -----
From: Bob Spidell <bspidell at comcast.net>
To: healeys at autox.team.net
Sent: Wed, 20 Feb 2019 23:19:47 -0500 (EST)
Subject: Re: [Healeys] Clutch and brake pedal issue
Well, did you get a good pedal?bs
On 2/20/2019 3:09 PM, Tom Felts wrote:
Please disregard this message below--I have figured it out.
I had to bleed the masters first before any fluid would come
into themtom
----- Original Message -----
From: Tom Felts <tomfelts at windstream.net>
To: healeys at autox.team.net
Sent: Wed, 20 Feb 2019 17:45:32 -0500 (EST)
Subject: Clutch and brake pedal issue
OK---so, I have replaced the clutch master and slave with new
units from HS. I have looked at the brake master and it is
clean as a pin. All lines to both systems are tight and there
is new fluid in the cannister.
Pumping the brake and clutch pedals as much as I can i can
build up no pressure at all in either. I had filled the
cannister before starting----and---I see no decrease in fluid
level in it after pumping the pedals.
Is it possible that the cannister is clogged up and won't let
fluid get to the masters? Other that that, I'm stumped as to
why I can build up no resistance in either system.
Any thoughts?
thankstom
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20190221/e97869f0/attachment.html>
More information about the Healeys
mailing list