[Healeys] Drum Balancing

[Keith Pennell]

Bob that is exactly what I did to balance several pairs.  Does that make me an "old fart"?  :):)



-----Original Message-----
From: Bob Spidell <bspidell at comcast.net>
To: healeys <healeys at autox.team.net>
Sent: Tue, Feb 20, 2018 11:17 am
Subject: Re: [Healeys] Drum Balancing

For my BJ8, we had an 'old fart' at an engine builder's shop balance the 
drums; he welded quarter-inch iron rod lengthwise between the fins (no 
metal removed).

I don't recall if we had the BN2's drums balanced, but there is a large, 
thick rib near the outer edge that had chunks cleanly machined off; it 
appears this would have been done at the factory.

Bob


On 2/20/2018 1:14 AM, A H List wrote:
> Drums are statically out of balance, i.e. there is more metal on one
> side due to casting/machining tolerances. To correct this only
> requires basic tools like a file and some patience, or take them to an
> engine balancer. I prefer to file a small amount over a large area so
> they don't look any different to originally whereas jobbing shops may
> use a drill to remove metal and it won't look original if that
> matters.
>
> Andy.
>
>
> On 2/20/18, Keith Pennell <llennep at verizon.net> wrote:
>> I did not understand that the drums were shaved, but the tires.  Shaving
>> drums merely makes it round around some point and nt necessarily the center
>> of mass.
>>
>>
>>

_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/llennep@verizon.net


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20180220/e8254807/attachment.html>