engl at accesscomm.ca
Sun May 28 20:42:17 MDT 2017
Bob is 100% correct - I went out and re-looked at the car, and from below
would work too. If you are replacing the angle drive at the same time it
could be a bit fiddly from below as the angle drive goes into the overdrive
right above the rear transmission mount, but I think doable. I can send
photos if you think this would be helpful.
From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Bob
Sent: May 28, 2017 7:49 PM
To: healeys at autox.team.net
Subject: Re: [Healeys] cable
Don't disagree, but just for the record, you can get the cable--with
sheath--off from below. The fitting should be finger tight, but if it's
torqued on you can use small channel lock pliers. It's tight, but I've done
If you just need to clean/lube the inner cable, simply unscrew the sheath
from the back of the speedo and pull the inner cable out.
Replacement is the opposite of removal.
On 5/28/2017 5:06 PM, Bob England wrote:
> Finally a question I can help with! As a new Healy owner I've been
> lurking on the list for the past few weeks, soaking up the questions
> and answers as best a new Healy owner can.
> Answer to your question Mike : from above. Definitely. Take the
> seats out, remove the radio console and transmission tunnel, and all
> is exposed. Did this earlier today on our BJ8 to replace a missing
> engine/bell housing bolt and did not take too long at all.
> -----Original Message-----
> From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of
> Mike S
> Sent: May 28, 2017 5:00 PM
> To: Healey List
> Subject: [Healeys] cable
> Any hints on replacing the speedometer cable on my BJ8? From above or
> MGTD (long gone)
> BN1 (long gone)
> BN2-100M (gone but in good hands)
Support Team.Net http://www.team.net/donate.html Suggested annual donation
Healeys at autox.team.net
More information about the Healeys