[Healeys] cable

[Bob Spidell]

Don't disagree, but just for the record, you can get the cable--with 
sheath--off from below.  The fitting should be finger tight, but if it's 
torqued on you can use small channel lock pliers.  It's tight, but I've 
done it.

If you just need to clean/lube the inner cable, simply unscrew the 
sheath from the back of the speedo and pull the inner cable out.  
Replacement is the opposite of removal.

Bob


On 5/28/2017 5:06 PM, Bob England wrote:
> Finally a question I can help with!  As a new Healy owner I've been lurking
> on the list for the past few weeks, soaking up the questions and answers as
> best a new Healy owner can.
>
> Answer to your question Mike : from above.  Definitely.  Take the seats out,
> remove the radio console and transmission tunnel, and all is exposed.  Did
> this earlier today on our BJ8 to replace a missing engine/bell housing bolt
> and did not take too long at all.
>
> Bob
>
> -----Original Message-----
> From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Mike S
> Sent: May 28, 2017 5:00 PM
> To: Healey List
> Subject: [Healeys] cable
>
> Any hints on replacing the speedometer cable on my BJ8?  From above or
> below.....?
>
> --
> Mike
>
> MGTD (long gone)
> BN1 (long gone)
> BN2-100M (gone but in good hands)
> BJ8
>
>
>
>