[Healeys] Engine ID Tag

[Michael MacLean]

Usually the drive pin is shorter than the drilled hole depth.  When the head is ground off, you can just drive the rest of the pin down in the hole and shorten the new pin a little and just drive it in the hole.  This is what I did on my Bugeye engine.Mike MacLean
 

    On Friday, July 1, 2016 4:19 PM, "gablegerry at netscape.net" <gablegerry at netscape.net> wrote:
 
 

  Has any one been successful replacing the Engine ID Tag?  I tried to tap the rivets in order to back them out.  Rivets too hard to tap.
Thanks
Hap 
 
 


_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/rrengineer.mike@att.net



 
  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20160701/c1ac2097/attachment.html>