[Healeys] spun bearings

[richard mayor]

I have seen a hub where the bearing had worn itself down into the hub about 1/8" and was a sloppy fit around the exterior as well. I believe this happened because the distance piece was left out but this is only a guess. 

Richard Mayor


> From: healeymanjim at hansencc.net
> To: healeys at autox.team.net
> Date: Fri, 30 Jan 2015 19:32:25 -0800
> Subject: [Healeys] spun bearings
> 
> I have changed many seals and have always had to drive out the bearing with a brass drift and drive it back in.  cannot imagine it spinning inside, but I have been wrong many times.
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> 
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
> 
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/mayorrichard@hotmail.com
> 
 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20150131/65ddf6fd/attachment.html>