[Healeys] Boot lid seal

[Stephen Hutchings]

Thanks Larry, but I don't think you quite got my question.I know which side is glued to the lid, but the seal itself has a different profile at each edge.My attachment is a cross section showing the difference. So, which edge is on the outside of the lid, and which goes toward the inside?
Stephen

      From: Larry Wendland <bighealey3k at aim.com>
 To: s.hutchings at rogers.com; healeys at autox.team.net 
 Sent: Tuesday, April 21, 2015 11:49 PM
 Subject: Re: [Healeys] Boot lid seal
   



-----Original Message-----
From: Stephen Hutchings <s.hutchings at rogers.com>
To: healeys <healeys at autox.team.net>
Sent: Tue, Apr 21, 2015 8:56 pm
Subject: [Healeys] Boot lid seal


 Stephen, The concave side faces the lip of the shroud.  The lip
contacts the seal in the center of the concave surface ideally.  

Larry
'67
BJ8



  
Hello listers,  
  
I'm about to glue on the trunk or boot lid seal, and I see that the two edges are slightly different.    
  
  
As per my attachment, one side is more bulbous, and the other is sharper.  
  
So...which side faces in, and which side faces out?  
  
  
  
  
Thanks,  
  
Stephen, BJ8  
  
 

_______________________________________________Support Team.Nethttp://www.team.net/donate.htmlSuggested annual donation  $12.75Archive:http://www.team.net/archiveForums:http://www.team.net/forumsHealeys@autox.team.nethttp://autox.team.net/mailman/listinfo/healeysUnsubscribe/Manage:http://autox.team.net/mailman/options/healeys/bighealey3k@aim.com
 



  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20150422/8823278b/attachment.html>