[Healeys] Boot lid seal
Larry Wendland
bighealey3k at aim.com
Tue Apr 21 22:30:29 MDT 2015
Stephen, I see what your saying now. It's been years since I changed my seal and will look at my lid tomorrow and let you know what I find.
Larry
'67 BJ8
-----Original Message-----
From: Stephen Hutchings <s.hutchings at rogers.com>
To: Larry Wendland <bighealey3k at aim.com>; healeys <healeys at autox.team.net>
Sent: Tue, Apr 21, 2015 11:58 pm
Subject: Re: [Healeys] Boot lid seal
Thanks Larry, but I don't think you quite got my question.
I know which side is glued to the lid, but the seal itself has a different profile at each edge.
My attachment is a cross section showing the difference. So, which edge is on the outside of the lid, and which goes toward the inside?
Stephen
------------------------------------------------------------
From: Larry Wendland <bighealey3k at aim.com>
To: s.hutchings at rogers.com; healeys at autox.team.net
Sent: Tuesday, April 21, 2015 11:49 PM
Subject: Re: [Healeys] Boot lid seal
-----Original Message-----
From: Stephen Hutchings < s.hutchings at rogers.com>
To: healeys < healeys at autox.team.net>
Sent: Tue, Apr 21, 2015 8:56 pm
Subject: [Healeys] Boot lid seal
Stephen, The concave side faces the lip of the shroud. The lip
contacts the seal in the center of the concave surface ideally.
Larry
'67
BJ8
Hello listers,
I'm about to glue on the trunk or boot lid seal, and I see that the two edges are slightly different.
As per my attachment, one side is more bulbous, and the other is sharper.
So...which side faces in, and which side faces out?
Thanks,
Stephen, BJ8
_______________________________________________Support Team.Nethttp://www.team.net/donate.htmlSuggested annual donation $12.75Archive: http://www.team.net/archiveForums:http://www.team.net/forumsHealeys@autox.team.nethttp://autox.team.net/mailman/listinfo/healeysUnsubscribe/Manage:http://autox.team.net/mailman/options/healeys/bighealey3k@aim.com
More information about the Healeys
mailing list