[Healeys] Question

[Alan Seigrist]

Did you put on a rear crank seal?  If so then crank case pressure will
probably vent upwards.  What about the crankcase ventilator on the
side of the motor, is it pulsing too?

On 6/26/11, Bob Spidell <bspidell at comcast.net> wrote:
> After bragging about our 100M's compression numbers I have a concern. We
> seem to be getting a lot of pulsed pressure in the valve cover, as felt at
> the oil filler hole. There is very little pressure at the end of the road
> draft tube. Given we have good compression, so, theoretically shouldn't have
> a lot of blow-by, what could cause pressure in the valve cover? The engine
> was totally rebuilt, and I believe we cleaned out the road draft tube but
> don't remember for sure (we were otherwise pretty careful).
>
> All hints, ideas, even knowledge welcome.
>
> TIA,
> Bob
>
> --------------------------------
> Bob Spidell - San Jose, CA
> _______________________________________________
> Healeys at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/healey.nut@gmail.com
>

-- 
Sent from my mobile device