[Healeys] bj8 folding rear seatback

[Rich C]

Andy,

That rear folding seat back assembly must sit immediately in front of the 
drain tubes, and must be matched with the rear quarter panels so their back 
edges meet perfectly. Rear outer left and right L shaped brackets will 
fasten and secure these panels at the outside back corners.
If you position the vertical panel just ahead of the drain tubes and align 
the corners of the rear quarter trims, you should have it. You'll have to 
carefully align where the captive speed nuts are in the sides of the panel 
and spot the holes through to suit. Same with the 3 holes for the bottom of 
the panel frame.

Rich
----- Original Message ----- 
From: "andy pole" <ampole at hotmail.com>
To: <healeys at autox.team.net>
Sent: Friday, January 22, 2010 7:52 AM
Subject: [Healeys] bj8 folding rear seatback


> Guys
>
>
>
> I had a new rear seat surround panel as well as new rear inner wings, 
> hence I
> have to drill the holes for the hinges in the surround panel and also the 
> hole
> in the wing for the fixing thru the wheelarch.
>
>
>
> Could anyone give me measurements for the hinge holes from the trunk 
> incline
> back panel and a guide for the wheelarch holes (I assume I will need to 
> match
> this with the hole in the seat panel but will need a guide?) Or do I need 
> to
> fix the interior quarter panels and match the corners?
>
>
>
> thanks for any help
>
>
>
> Andy
>
> _________________________________________________________________
> Got a cool Hotmail story? Tell us now
> http://clk.atdmt.com/UKM/go/195013117/direct/01/
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler at quickclic.net
>
> http://www.team.net/archive

[demime 1.01d removed an attachment of type image/jpeg which had a name of 000_0499.jpg]