[Healeys] seat belt attachment question

[John Loftus]

Hi all,

I'm trying to sort out my 3 point type seat belts on the BJ7. My 
understanding is the drive shaft tunnel has an eyelet anchor point 
(eyelet bolted to side of tunnel). The short belt (with buckle) is 
attached to the eyelet with a hook type clasp.

My question concerns the outboard attachment. Is that also supposed to 
be a hook type clasp going to an eyelet? Or does the outboard belt just 
bolt directly to the floor? My belts have just a simple single hole 
bracket for this end. I could bolt this to the floor but then the belt 
routing isn't great i.e. it would be better if the belt bracket was 
perpendicular to the floor.

The factory service bulletin A-437 
<http://www.healey6.com/bulletins/Seat%20Belt-ASJ.pdf> shows some type 
of 90 degree bracket. But at the same time they don't show any eyelets 
and hook type clasps being used.

They also show the bracket for the rear wheel arch (shoulder belt 
attachment) having a two hole bracket. My belt has just one hole in the 
bracket.

Any guidance appreciated!

Cheers,
John