[6pack] Front End Dis-assy

[Bob]

Hello,

Easy to build. Get a length of 3/4 threaded rod. 4 washers and 2 nuts. 
Or you can weld/braze a bar at the bottom like I did. You feed the rod 
through the hole where the shock goes. Easy and safe as John says below.

Bob.

On 10/12/22 12:52 PM, John Cyganowski wrote:
> 2.??????Remove spring and spring pan (per Bentley)
>
> Bruce-
>
> Be very careful with this step. The spring pan is under considerable 
> pressure from the shock spring. I don’t know your shop’s experience 
> with these cars, but removing the spring pan without a spring 
> compressor can cause injury and damage. The common spring compressors 
> that fit to the outside of the spring in my mind are dangerous. You 
> need a threaded rod type to put into place of the shock. Then you can 
> decompress the spring safely. You can make a compressor, or I can lend 
> you mine?
>
> John Cyg
> 70 Damson
> CC52927LO
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.96
> Archive: http://www.team.net/archive
>
>
> 6pack at autox.team.net
> http://autox.team.net/mailman/listinfo/6pack
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/6pack/yellowtr@adelphia.net
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/6pack/attachments/20221012/5322b75e/attachment.htm>