[6pack] Front End Dis-assy

[im sloane]

John - Bob,
Didn't he say that's what he was going to do in 2-b?

Sloane

________________________________
From: 6pack <6pack-bounces at autox.team.net> on behalf of Bob <yellowtr at adelphia.net>
Sent: Wednesday, October 12, 2022 6:48 PM
To: John Cyganowski <janah at att.net>; 6pack at autox.team.net <6pack at autox.team.net>
Subject: Re: [6pack] Front End Dis-assy


Hello,

Easy to build. Get a length of 3/4 threaded rod. 4 washers and 2 nuts. Or you can weld/braze a bar at the bottom like I did. You feed the rod through the hole where the shock goes. Easy and safe as John says below.

Bob.

On 10/12/22 12:52 PM, John Cyganowski wrote:
2.??????Remove spring and spring pan (per Bentley)

Bruce-

Be very careful with this step. The spring pan is under considerable pressure from the shock spring. I don’t know your shop’s experience with these cars, but removing the spring pan without a spring compressor can cause injury and damage. The common spring compressors that fit to the outside of the spring in my mind are dangerous. You need a threaded rod type to put into place of the shock. Then you can decompress the spring safely. You can make a compressor, or I can lend you mine?

John Cyg
70 Damson
CC52927LO



_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.96
Archive: http://www.team.net/archive





-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/6pack/attachments/20221014/6525c8d4/attachment.htm>