[6pack] Throttle Linkage ?S? Connectors

[robert rudolphi]

To follow up on this I am having my carbs rebuilt this winter (Joe Curto) and was thinking about have the intake and stock exhaust manifolds Jet coated. I am trying to reduce hard starting when hot. Would also like to get the throttle linkages re-plated/refinished and was wondering what is the best way to go?

Thanks in advance for any feedback

Robert





On Tuesday, November 23, 2021, 12:13:49 PM EST, Tomislav Marincic <tomislav.marincic at earthlink.net> wrote: 






When I set up my dual ZS175’s I used new link clips from Roadster Factory. They quickly became distorted and introduced slop into the linkage.

I’m currently using one SU link clip sourced from Richard Good, which is much sturdier and more rust-resistant than the ZS part. I’m also using a single rigid coupling that I sourced from Grainger. I forget why, but installing two shaft linkages was problematic, and the gap between carb throttle shafts was too wide to use two SU linkages.

I might have one of each in my spares if you need them.

https://www.grainger.com/search?searchQuery=nomar+clx-5-5-a&searchBar=true

https://www.goodparts.com/product/folded-coupler-carb-shaft/

Pix on request…Tom



_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.96
Archive: http://www.team.net/archive


6pack at autox.team.net
http://autox.team.net/mailman/listinfo/6pack

Unsubscribe/Manage: http://autox.team.net/mailman/options/6pack/robertrudolphi@yahoo.com