[6pack] Fuel filler orientation

[DAVID MASSEY]

 That's different than on my 71 which has two tank vents and a vent on the filler neck.  Interesting.
 
Dave 

 
 
-----Original Message-----
From: Richard Lindsay via 6pack <6pack at autox.team.net>
To: TR6 <6pack at autox.team.net>
Sent: Sun, Nov 3, 2019 5:55 pm
Subject: Re: [6pack] Fuel filler orientation

On my 1975 car, the tank vent is on the tank. The vent port ofn the filler casting is not drilled.

On Sun, Nov 3, 2019, 4:34 PM DAVID MASSEY <dave1massey at cs.com> wrote:

 It's not that trivial since the tank vent nipple is mounted to the filler and spinning it around will require replumbing the vent tubes.  If you wish to avoid that step check where it was before and go from there.  On my car it is hinged on the right.
 
Dave 

 
 
-----Original Message-----
From: Richard Lindsay via 6pack <6pack at autox.team.net>
To: TR6 <6pack at autox.team.net>
Sent: Sun, Nov 3, 2019 10:50 am
Subject: [6pack] Fuel filler orientation

Hello friends,    If you've followed any of the work on my '75 US specification TR6 you will know that the following question is probably irrelevant...but I ask anyway, for your sage advice:
When reinstalling the fuel filler cap, which is the correct orientation? Hinge side toward the front. Or rear? Or to one side or another?
   Thanks in advance of your reply.
Rick_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/6pack/attachments/20191104/1c843571/attachment.htm>