[6pack] Fuel filler orientation

[Richard Lindsay]

On my 1975 car, the tank vent is on the tank. The vent port ofn the filler
casting is not drilled.

On Sun, Nov 3, 2019, 4:34 PM DAVID MASSEY <dave1massey at cs.com> wrote:

> It's not that trivial since the tank vent nipple is mounted to the filler
> and spinning it around will require replumbing the vent tubes.  If you wish
> to avoid that step check where it was before and go from there.  On my car
> it is hinged on the right.
>
> Dave
>
>
>
> -----Original Message-----
> From: Richard Lindsay via 6pack <6pack at autox.team.net>
> To: TR6 <6pack at autox.team.net>
> Sent: Sun, Nov 3, 2019 10:50 am
> Subject: [6pack] Fuel filler orientation
>
> Hello friends,
>    If you've followed any of the work on my '75 US specification TR6 you
> will know that the following question is probably irrelevant...but I ask
> anyway, for your sage advice:
>
> When reinstalling the fuel filler cap, which is the correct orientation?
> Hinge side toward the front. Or rear? Or to one side or another?
>
>    Thanks in advance of your reply.
>
> Rick
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/6pack/attachments/20191103/b8bfd0e8/attachment.htm>