[6pack] tranny problem

[Navarrette, Vance]

	Put the tranny in gear, and rotate the output flange a bit. This will in turn
cause the input shaft to rotate, hopefully allowing the splines to align
between the clutch disk and the input shaft.

	Vance

      Vance Navarrette
      http://www.triumphowners.com/832

-----Original Message-----
From: 6pack-bounces at autox.team.net [mailto:6pack-bounces at autox.team.net] On
Behalf Of oliver
Sent: Wednesday, June 23, 2010 5:07 PM
To: Triumph 6 Pack
Subject: [6pack] tranny problem

hi, all.  I had to remove the tranny to replace the ring gear.  I noticed
the bearing was also scored, so I replaced it as well.

I put the flywheel and the clutch back, using the alignment tool, but we
can't seem to fit the gearbox.

it gets within 1/2 to 1 inch but no farther.

any ideas what's wrong?

thanks!
_______________________________________________

6pack at autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/6pack/vance.navarrette@intel.com