Is anyone else having a problem downloading this PDF file, or is it just me?
Larry Hoy
>-----Original Message-----
>From: owner-vintage-race@autox.team.net
>[mailto:owner-vintage-race@autox.team.net]On Behalf Of Steven
>Silverstein
>Sent: Monday, January 15, 2001 7:44 PM
>To: Sadek Charles H DLVA; Vintage
>Subject: Re: Wheel Lug nuts
>
>
>You might want to check:
>
>http://www.mrlugnut.com/
>
>Mr. Lugnut...They have a downloadable PDF catalog. They have numerous
>solutions but I am not positive they will have your specific need.
>
>Steve Silverstein
>
>
>
>
>on 1/15/01 7:40 PM, Sadek Charles H DLVA at SadekCH@nswc.navy.mil wrote:
>
>> Folks,
>> I have been looking for two types of wheel nuts for 7/16-20 studs.
>> The first is the normal American taper seat and the second would be a
>> straight shoulder shank for mag wheels. I need a long hex surface; about an
>> inch and a half to two inches and they should be open-ended. (There is
>> little clearance to the mag wheel spoke-Compmotive reproduced Minilites. We
>> have a very large bolt hole circle - 4 3/4"). Does anyone know who makes
>> such an animal? I have seen them on Mustangs, etc.
>> Thanks,
>> Chuck Sadek
>> Yenko Stinger
>> YS 73
|