You might want to check:
http://www.mrlugnut.com/
Mr. Lugnut...They have a downloadable PDF catalog. They have numerous
solutions but I am not positive they will have your specific need.
Steve Silverstein
on 1/15/01 7:40 PM, Sadek Charles H DLVA at SadekCH@nswc.navy.mil wrote:
> Folks,
> I have been looking for two types of wheel nuts for 7/16-20 studs.
> The first is the normal American taper seat and the second would be a
> straight shoulder shank for mag wheels. I need a long hex surface; about an
> inch and a half to two inches and they should be open-ended. (There is
> little clearance to the mag wheel spoke-Compmotive reproduced Minilites. We
> have a very large bolt hole circle - 4 3/4"). Does anyone know who makes
> such an animal? I have seen them on Mustangs, etc.
> Thanks,
> Chuck Sadek
> Yenko Stinger
> YS 73
|