Contact Art Lipp,
lipp04@yahoo.com
for a bushing system that's easy to install and works!
NFI and all that,
Ed Woods
----- Original Message -----
From: "Andrew Uprichard" <auprichard@uprichard.net>
To: glemon@neb.rr.com, triumphs@autox.team.net
Sent: Monday, April 15, 2013 10:23:42 PM
Subject: Re: [TR] TR6 Accelerator shaft bushings
Reminds me of the three little rubber pieces which support the wiper motor
on the TR3. B Not sure that I've ever managed to put them in without slicing
them first.
Andrew Uprichard
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of glemon@neb.rr.com
Sent: Monday, April 15, 2013 9:21 PM
To: triumphs@autox.team.net
Subject: Re: [TR] TR6 Accelerator shaft bushings
Good to know there is a commercially available product that works for the
bushings. B I tried the ones from the Roadster Factory and no combination of
warming it to make it soft lubrication force and finally some trimming could
get them in. B I am by no means the best mechanic but am pretty dogged and
persistent. I gave up and spent much less time fabricating a couple washers
welded to some steel tube. B Has worked fine for a couple years. B Greg Lemon
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/triumphs/auprichard@uprichard.net
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/triumphs/fogbro1@comcast.net
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|