| To: | triumphs@autox.team.net |
|---|---|
| Subject: | [TR] TR6 Accelerator shaft bushings |
| From: | Keith Stewart <keithstewart@execulink.com> |
| Date: | Mon, 15 Apr 2013 15:09:54 -0400 |
| Cc: | dctr6@optonline.net |
| Delivered-to: | mharc@autox.team.net |
| Delivered-to: | triumphs@autox.team.net |
| References: | <mailman.17.1366048803.11289.triumphs@autox.team.net> |
On Mon, 15 Apr 2013, at 12:02 PM, Dennis Culligan wrote: > If I know a machinist that can fabricate the parts, is brass the best way to go? > Any other bright ideas? I do NOT want to have to do this again. You might try Art Lipp. He makes a bushing kit for the accelerator shaft. His email address is: lipp04@yahoo.com Keith Stewart keithstewart@execulink.com ** triumphs@autox.team.net ** Archive: http://www.team.net/archive |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TR] TR6 Accelerator shaft bushings, Bob Danielson |
|---|---|
| Next by Date: | Re: [TR] TR6 performance, McGaheyRx |
| Previous by Thread: | Re: [TR] TR6 Accelerator shaft bushings, Bob Danielson |
| Next by Thread: | Re: [TR] TR6 Accelerator shaft bushings, glemon |
| Indexes: | [Date] [Thread] [Top] [All Lists] |