triumphs
[Top] [All Lists]

[TR] Fuel Shutoff valve question

To: "'triumphs@autox.team.net'" <triumphs@autox.team.net>
Subject: [TR] Fuel Shutoff valve question
From: Mark Hooper <mhooper@indiefilmnet.com>
Date: Tue, 15 May 2012 16:39:00 -0400
Delivered-to: mharc@autox.team.net
Delivered-to: triumphs@autox.team.net
Dkim-signature: v=1; a=rsa-sha256; c=simple; d=indiefilmnet.com; s=MDaemon; t=1337114249; x=1337719049; q=dns/txt; h=DomainKey-Signature: Received:Date:From:Subject:To:In-Reply-To:Message-ID: Organization:MIME-Version:Content-Type:Content-Transfer-Encoding: Reply-To; bh=IbWnd7yoXhPFUHZKs8OF+5CgkdXq0WqlXUDV1oxdeSM=; b=H+u gcmmjdcZD0SJPhKTjWtW42iKwXsYbYHSlX2QZM84X+LLGHhSkXz/F29IXFC8zX7c MhFLQ/pFqXeNxZUYHGw6DgIiPoE9zehl+mzqgLVQuKGtoA7G8Rzqm2vdYc6PWQBw WoUBEQbZaCAQPiG+KkkWi27FydiwvZBSLkDHFK08=
Domainkey-signature: a=rsa-sha1; s=MDaemon; d=indiefilmnet.com; c=simple; q=dns; h=from:message-id; b=gsCQCjssJxDGbrx8Txlhbd2hNrTzdOivZng4Qgejz6nBOC9Jv3FUfno8Qe13 aOz9S6d5y0FH6wq8Hr8iGwMR0pvJIQ1T5Jxm07LnqlCI4bITnMKbiLS3Q gpOak01cPwpRxAH+sRyvZLqSZJeFnqOXWkkr6QeuBwWbZaG+1JEYaw=;
In-reply-to: <28864CA9032846B59DD7511771AB59C4@AlexPC>
List-archive: <http://autox.team.net/pipermail/triumphs>
List-help: <mailto:triumphs-request@autox.team.net?subject=help>
List-id: Triumph Sports car discussion <triumphs.autox.team.net>
List-post: <mailto:triumphs@autox.team.net>
List-subscribe: <http://autox.team.net/mailman/listinfo/triumphs>, <mailto:triumphs-request@autox.team.net?subject=subscribe>
List-unsubscribe: <http://autox.team.net/mailman/options/triumphs>, <mailto:triumphs-request@autox.team.net?subject=unsubscribe>
Organization: IndieFilmNet
Reply-to: mhooper@indiefilmnet.com
Sender: triumphs-bounces@autox.team.net
I'm planning to put a solenoid fuel shut-off valve in my TR6's fuel line. I
keep getting fuel draining into the sump, despite having a filter in the fuel
line and 3 recently rebuilt carbs.

I found an interesting site: www.altfuel.com which has quite a selection of
valves. I have a question about the specs which are as follows:

Part number 7008A-12V-O is a pilot operated 12 volt electrically operated fuel
shut off. This is a U.L. listed valve for LPG and gasoline. The 7008 series
valves are 1800 inlet to outlet with 1/4 NPT threads. This valve is assembled
and 100% tested at Alternative Fuel Systems, Inc. It has been the standard in
LPG fuel systems for over 30 years for its reliability and durability

Voltage: 12 VDC
Watts: 6
Amperage: .5
Max. Pressure: 312 P.S.I.
Orifice: 1/4"
Max. Ambient Temp.: 1400 F
Max. Fluid Temp.: 770 F
Lead Termination: None
Certification: U.L. (MH8621)

Isn't the maximum fuel temperature of 77 degrees F rather low? I mean the gas
in any tank in Arizona must get a lot hotter than that on a daily basis. And
most under-car fuel tanks sitting in parking lots in the summer must be over
80 degrees. For sure, on the TR6 the valve will be under the car so will
likely get quite warm until the fuel starts flowing from the tank.

However, all the fuel valves seem to have the same limit. Am I
misunderstanding something, or is this just the wrong type of equipment?

Mark
1972 TR6

** triumphs@autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: 
http://autox.team.net/mailman/options/triumphs/mharc@autox.team.net

<Prev in Thread] Current Thread [Next in Thread>