triumphs
[Top] [All Lists]

[TR] Float bowls overflowing

Subject: [TR] Float bowls overflowing
From: elliottr at rmi.net (Roger Elliott)
Date: Sat, 12 May 2012 12:21:58 -0500
References: <2c65d.60ae0163.3cdd75e8@aol.com> <1336686808.65854.YahooMailNeo@web120206.mail.ne1.yahoo.com>
I want to thank everyone for the suggestions and ideas.

I hooked up a pressure gauge today - fuel pressure was almost 10 psi.  I 
put in a pressure regulator and the pressure is now just over 2 1/2 psi.

I now have it set so it is running about 95% right. I think I just need 
to make the carbs a little richer.

Just to follow up on a couple of suggestions.  I could not detect any 
gas in the floats that were originally in the carbs.   I replaced them 
and still had the overflow problem.

The floats are the solid plastic ones - no metal arms. I set them so a 
drill bit between 1/8" and 3/16" inches (per Spit manual) would just 
roll under the float.

So I think I am all set.  Thanks again for all of the ideas.

Roger Elliott



On 05/10/2012 04:53 PM, Frank Fisher wrote:
> imleaning away from fuel pump pressure as he only has one bowl leaking
> Frank
>
> *From:* "Chip19474 at aol.com" <Chip19474 at aol.com>
> *To:* elliottr at rmi.net; triumphs at autox.team.net
> *Sent:* Thursday, May 10, 2012 12:50 PM
> *Subject:* Re: [TR] Float bowls overflowing
>
> Roger,
>
> Cracked floats would do it!  The floats get saturated with fuel and  
> don't
> "float" anymore!  I would suspect your fuel pump pressure but you  
> said it
> ran fine with that fuel pump until now.  I assume you're  using a fuel 
> filter
> so we can rule out nasty bits of dirt clogging the  valves....if the 
> float
> level is set to spec and the pump hasn't suddenly decided  to put out 
> 8 or
> 10psi, I'm guessing that there's a crack in one of your  floats.
>
> Chip Krout
> Delaware Valley Triumphs, Ltd.
> Skippack,  PA
> 1976 TR6 CF57822U
>
>
>
> In a message dated 5/10/2012 12:07:24 P.M. Eastern Daylight Time,
> elliottr at rmi.net <mailto:elliottr at rmi.net> writes:
>
> Assuming  I haven't botched installing the needle valves and floats, is
> there anything  besides excess fuel pressure that would cause the 
> bowls to
> overflow?

<Prev in Thread] Current Thread [Next in Thread>