Geo & Kathleen Hahn wrote:
> I used a 1/4" grade 8 bolt. Got one with a long enough shank that
> there were no threads inside the shaft, had to shorten it a bit for
> best fit. Used a Grade 8 self locking nut. Some use a larger bolt,
> some a roll pin... I think all these methods are significantly better
> than just relying on that pesky pin.
>
> http://www.cybertrails.com/~ahwahnee/cross%20bolt.JPG
>
> Hole for the bolt is drilled perpendicular to the stock pin. Pretty
> easy drilling with a hand drill.
>
> Geo
George,
Is that a bronze bearing carrier I see in th photo??
--
Glenn A. Merrell
Chairman, Triumph Stag Club USA (2007-2009)
The best trophies are miles on the odometer, stone chips in the paint, dead
bugs on the windshield!
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|
