> Evening all,
>
> I think we have talked about this before, but memory is lacking. I'm
> collecting together the parts I need to wire in the lamps and I have found
a
> steel 3position toggle switch, the type that requires a 7/16" hole and has
a
> "baseball bat" lever. I think this would look fine, any opinions? What
> about labelling?
>
================================================================
Mount it on the heater/dash support brace under the dash on the drivers
side, I would not cut my dash for this switch, works very well and no
labeling needed, I have 5 switches mounted this way "FT"
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|