I am trying to put the rivets back in the doors and rear quarter panels for my
TR6 and I am a bit perplexed.
The rear bulhead has five threaded holes...but no holes to place any snaps. I
remember the five threaded holes being for the soft top. I also know that I
was never able to have the soft top and the tonneau on at the same
time...because my soft top did not have the female portion of the snaps on the
rear of it. However, there was a time that I had the soft top frame out and
was just using the tonneau and the hardtop. My questions are:
1) Are there snaps attached to rear deck of the car for a tonneau and maybe the
holes for these snaps got covered up at the body shop when it was repainted?
If not, is my memory just very faulty and I never had the tonneau snapped down
in the rear when I was using it?
2) Should there have been female snaps on the rear of my soft top? The soft
top I have came from TRF has the reflective stripes, the zip out rear window,
and came with the snaps needed to snap it down to the rear quarter panels
already attached to it.
Please someone shed some light as to whats going on here
Jonathan.
|