In a message dated 98-08-05 09:14:20 EDT, a3graham@mc1adm.uwaterloo.ca writes:
<< Finally getting to the stage of reassembling my 3A chasis. Does anyone
have any experience with how many engine components can be installed on a
"rolling chasis" and still be able to lower the body on the frame? With
all of the extra room, would be nice to install manifolds, carbs on the
engine in the frame. Also, exhasut system would be a lot simpler as well.
Have seen photos of frames with quite a few components on the engines. >>
Angelo:
We "totally" reassembled my TR3-B engine and frame so we could run the engine.
That meant complete exhaust system, intake manifold and carbs, but not gas
tank. When we decided to put the body tub on all we had to do was remove the
carbs. I'm pretty sure the intake manifold can stay, along with exhaust and
everything else.
G'luck..
Don Marshall
|