Re: TR6 Rear Hub Studs

[scott suhring <suhring@lancnews.infi.net>]

Bob:

Thanks for the vote of confidence. Finished the job tonight.
Ended up packing the stud with about 7 washers and using the
tire iron and lug nut to draw in the stud. Used some lock
tight as an extra measure. The stud was a bit different
in taper than the others but appears to have set fine.

Boy, getting the hold-down pin on was a bitch! Trying to 
comprese the clip and then turn the pin to lock in was
challenging, but persistance paid off.

Thanks again for the help (as well as all those on the
list that responded).

Scott Suhring
Elizabethtown, PA
'70 TR6