At 10:15 PM 5/5/98 -0400, you wrote:
>
>Excuse my ignorance, but why would one wish to put 90 weight gesr oil in the
>trunions?
>
>
That is the recommended lubrication.
The threaded stub at the bottom of the vertical link is drilled, with a
horazontal hole about 2 1/2 inches from the bottom. A zerk fitting can be
installed there to pump a small amount of oil into the space between the
trunnion and the vertical link. These parts move against each other, and
as such, should be lubricated.
Thomas Howard
'72 GT6, (and a good bit of USA Iron)
Lakeside Union School District
|