TR4 metal dash

[Malcolm Walker <walker05@camosun.bc.ca>]

The dash is out and cleaned!  I feel much better now.

A few ponderings, though--

There are 2 metal 'cuts' (?) down at the bottom center, about the control
panel (wiper,choke,etc).  Are these primitive crumple zones, or are they
not supposed to be there?

I am going to leave it alone, but I'm a bit curious all the same.

Does anyone know the thread size for the knurled nuts on the back of the
gauges?  I broke a stud... there's lots of bolt left but I will need a new
nut.

Thanks,
-Malcolm