Someone asked about this a couple of weeks ago, and I just got around to
measuring. So here is the complete skinny as far as I know for Post
TS60000 TR3A:
The windscreen bottle is 4 inch dia, 7-1/2 inch high translucent white bottle.
Raised lettering on bottle "Trafalgar Product Manufactured by John Sydney
Limited"
Top black metal screw-on with brass nipple in center. Nipple has one way
check valve.
Holder, is tin plated steel, 'L' shaped with offset ring clamp to secure
bottle. 1/16 inch thick black sheet rubber pad, 3/4 wide, glued to bottom
of 'L'. Longer piece glued in side of 'L'. 1/2 inch wide, 1/16 inch
thick, black sheet rubber glued to inside of clamp One piece on ether side
of 'L'. Purpose to protect bottle.
Washer bottle assy fits to left inner wing near coil. Bottle holder
attached to body with 2 screws. Top screw hole location. Measure 6 inches
down from inside of wing mounting flange (closest to coil). Mesure 6
inches forward from the bulkhead, 6 inches down. The top mounting screw
goes there.
Washer pump is manual push type. It mounts on the dash board in the little
lower triangle formed by the insturment panel and the cubby box lid. The
outer fixing nut is a chromed hex nut.
It has a long thin shaft. At the end is a black large diameter flatish button.
In an arch around the top half of the button it says, "SCREEN WASHER" In
the center it says "PUSH"
I hope this helps people seting up a washer system or in trying to identify
the correct parts.
TeriAnn
twakeman@scruznet.com
|