Good News, Bad news

[STUART_BRENNAN@HP-Andover-om3.om.hp.com]

     O.K., so I finally got my backwards thread wheel studs out of my RF 
     hub this weekend.  They came out relatively easy, using just an 
     antique acme thread C-clamp.  So much for the good news.  Time for the 
     bad:
     
     These backwards studs were non the same brand, so the PO had to open 
     up the holes in the hub just a few thousandths.  The proper studs now 
     can wiggle around a bit in the holes.
     
     I'm thinking of using some 0.002" shim stock to fill up the gap, 
     restoring the press fit.  
     
     Does this sound like a reasonable solution?
     
     Stu