| To: | <spridgets@autox.team.net> |
|---|---|
| Subject: | Re: pressing piston pins |
| Date: | Fri, 24 Feb 2006 18:34:45 -0600 |
| References: | <314249905.20060224171928@midsouth.rr.com> |
I've seen this done at machine shops, but I think they heat the rods to higher temperature. I don't think it would hurt to try it though. At my dad's shop we had a hydraulic press that did this, without heat. > Anyone here installed piston pins? Can I just put the pins in the > freezer and the rods in a 250 degree oven and then carefully push > them in? |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: pressing piston pins, Frank Clarici |
|---|---|
| Next by Date: | Re: pressing piston pins, bjshov8 |
| Previous by Thread: | Re: pressing piston pins, Frank Clarici |
| Next by Thread: | Re: pressing piston pins, bjshov8 |
| Indexes: | [Date] [Thread] [Top] [All Lists] |