Re: pressing piston pins

["K. Valentine" <kevin@valentinephoto.net>]

On Feb 24, 2006, at 6:19 PM, Rick Sorak wrote:


>   Anyone here installed piston pins? Can I just put the pins in the
>   freezer and the rods in a 250 degree oven and then carefully push
>   them in?
Rick,

Best bet is to take them to your local machine shop and have them do  
it.  It should only cost a couple of bucks and they may even do them  
while you wait.

Kevin V.

Your messages not reaching the list?
Check out http://www.team.net/posting.html

===  Help keep Team.Net on the air
===     http://www.team.net/donate.html

===  unsubscribe/change address requests to majordomo@autox.team.net  or try
===  http://www.team.net/cgi-bin/majorcool
===  Other lists available at
===      http://www.team.net/mailman/listinfo
===  Archives at http://www.team.net/archive
===  http://www.team.net/the-local
===  Edit your replies!