I made my own.
I went to NAPA and bought a sheet of gasket material and traced the
originals and cut out the new ones.
Cost about $5.00 for the sheet, used just a little for the door handles the
rest is ready for anything else that may need a gasket
-----Original Message-----
From: spitfires-owner@autox.team.net [mailto:spitfires-owner@autox.team.net]
On Behalf Of griffco
Sent: Tuesday, August 12, 2003 9:50 PM
To: Kevin Rhodes
Cc: spitlist
Subject: Re: Door handle gaskets?
The original ones I got from TRR were black tarred paper and have held up
for 10 years - occassional driving, mind you.
The latest ones I got from Vic Brit were simply tan cardboard. Much less
robust looking.
I varnished them with urethane floor varnish, both sides before installing
them. First coat of the thin varn ish soaked into the coardboard. Hope
they hold up.
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|