I used the 3n1 insulation (from VB), cut to fit (using the old insulation as
a pattern) and edged with aluminum tape (to keep the water out of the
insulating material). I glued the insulation to the inside of the tranny
cover, and stapled the edges for good measure.
Dan
-----Original Message-----
From: spitfires-owner@autox.team.net
[mailto:spitfires-owner@autox.team.net]On Behalf Of mark holbrook
Sent: Wednesday, June 13, 2001 3:37 PM
To: spitfires@autox.team.net
Subject: Insulation
I don't think the last email I sent out went, but if
it did just ignore this email. I am looking for a
good insulator that will stop the heat/cold coming
through the trans tunnel area. It has to be weather
resistant as it will be exposed to water when it rains
because I will put it where the existing old
insulation is, under the trans tunnel. any ideas?
Mark
=====
-Mark Holbrook-
Get personalized email addresses from Yahoo! Mail - only $35
a year! http://personal.mail.yahoo.com/
/// spitfires@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe spitfires
///
|