[Shop-talk] Tile backer board on concrete floor

[fishplate at gmail.com (Jeff Scarbrough)]

On Fri, Oct 28, 2011 at 8:11 PM, Karl Vacek <kvacek at ameritech.net> wrote:
> Any advice will be appreciated.

Not advice, per se, but thoughts...

I'd use a hard backerboard, and I'd put the thinset down.  Your goal
should be to make a surface that doesn't flex; so you need the
gap-filling of the thinset to make sure there aren't any voids under
the board.  If it's a slab in contact with the ground, I'd use the
moisture-proof board (I think it's green around here).  A stout board
will make up the height easily and flex less.

Jeff Scarbrough
Corrosion Acres, Ga.