shop-talk
[Top] [All Lists]

Re: [Shop-talk] Head Stud Install

To: chad@linuxeg.com
Subject: Re: [Shop-talk] Head Stud Install
From: Ronnie Day <ronnie.day@gmail.com>
Date: Sat, 24 Apr 2010 07:19:45 -0500
> Chad

> I'm replacing the head bolts on my SBC with ARP studs.
> With the cap screws I used ARP's sealant (the bolts holes
> open into the water jacket). I'd like to Loctite the studs in place
> but not sure which produce to use. On the mains I used #262 (red)
> but #271 "locks and seals (Enco catalog page 917) so I'm thinking this
> may be a better choice - the catalog continues "...bearing retaining nuts,
> cylinder liner studs, door closer plugs, ..." Any recommendations?
> Sure was easier when all they had was "Nutlock" and Studlock"!

I'd call Loctite or send them an email.

FWIW,
Ron
_______________________________________________

Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>