My Lincoln SP-125 doesn't have a purge switch either. I have to open the lid
and temporarily disengage the wire feed roller to purge it.
Doug
--- On Mon, 2/2/09, Marc <smarc@smarc.net> wrote:
> From: Marc <smarc@smarc.net>
> Subject: Re: [Shop-talk] Basic MIG Welding questions
> To: "Shop Talk List" <shop-talk@autox.team.net>
> Date: Monday, February 2, 2009, 10:41 PM
> Well, there's a purge setting on the 180, which is
> basically just a wire
> feed speed of 0. I use the purge setting to set gas flow
> without wasting
> wire. Maybe you could rig up a switch to open the circuit
> to the feed
> motor...
>
>
> Jim Stone wrote:
> > Not as far as I can tell. The owner's manual
> doesn't indicate
> > anything about purging per se, but here's how it
> describes setting the
> > gas flow rate:
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|