shop-talk
[Top] [All Lists]

RE: Welding/cutting table

To: John Miller <jem@milleredp.com>, Shop-Talk
Subject: RE: Welding/cutting table
From: "Madurski, Ronald M" <ronald.m.madurski@lmco.com>
Date: Tue, 23 Nov 2004 11:53:22 -0500
This stuff bends very easily in one direction.  You would probably have to 
support it by welding in a strap across the open ends.  It is also very heavy 
stuff, just guessing I'd say about 8-10 lbs/sq.ft.

Later,

Ron Madurski
> -----Original Message-----
> From: shop-talk-owner@autox.team.net
> [mailto:shop-talk-owner@autox.team.net]On Behalf Of John Miller
> Sent: Sunday, November 21, 2004 6:09 PM
> To: Shop-Talk
> Subject: Welding/cutting table
> 
> The goal here is to 30x60in surface, hinged off the back of my Vidmar 
> cabinets.  This is about all I have room for, and it needs to 
> be able to 
> fold out of the way.  My thoughts are as follows:
> 
> a) A piece of welded boiler-decking e.g. 
> http://www.mcnichols.com/products/bargrating/welded/ as the cutting 
> surface.  It should be rigid enough and flat enough, and just about 
> manageable on the weight front.






<Prev in Thread] Current Thread [Next in Thread>