There are also bits available to drill square holes.
Dave Russell
Eric J Russell wrote:
>>Today I was in the local Grainger store, for a minute. they had wood bits
>>that drill curved holes and around corners. I didn't have time to figure
>>them out. any one explain them to me?
>
>
>
> Left over April First display?
>
>
>
>
> Seriously, the type I've seen are like a spade bit but with a rounded end.
> It will allow one to start the hole and then angle the drill motor to pivot
> the cutting end of the bit and bore a curved hole (within the limits of the
> shaft of the bit)
>
> Eric Russell
|