shop-talk
[Top] [All Lists]

Re: Shop Safety

To: "Mark Watson" <watsonm05@comcast.net>, <shop-talk@autox.team.net>
Subject: Re: Shop Safety
From: "Bill Engle, Sr." <whesr@iglou.com>
Date: Fri, 02 Apr 2004 11:14:35 -0500
Teeth way to course.  You might be able to do that if you used a very fine 
tooth carbide blade.  The key to metal saws is to always have two teeth in 
contact with the metal  at all times ( the work must be wider than the 
distance between the teeth.

That could have been really unpleasant.
Bill



At 09:35 AM 4/2/2004, Mark Watson wrote:

>Here's a copy of a good safety topic with a link:
>
>________________________________________________________________________
>
>Message: 1
>    Date: Thu, 01 Apr 2004 20:18:48 -0000
>    From: "cooltool49" <cooltool49@yahoo.com>
>Subject: Messed up again
>
>Hi all.
>I'm still shaking about an incident that just ocurred a few minutes
>ago in my garage/shop.
>This is a bit off topic; however, shop safety should be of serious
>concern to all of us.  I was very lucky.
>The following link it to my personal site, which I never use.  I'll
>leave the files on there for a couple of weeks.
>I'm not proud of my stupidity, but display this to prevent someone
>else from encountering the same type of accident(maybe with less
>positive results)
>Je






<Prev in Thread] Current Thread [Next in Thread>